AFC Range: ± 300 kHz
Sensitivity: 2 µV at 12 dB Sinad with squelch defeated
Squelch: Squelches at 10 µV for min. 50 dB S/N ratio
Input Overload: 20 mV
Frequency Response: 100 – 10 kHz, ± 3 dB
Signal-to-Noise Ratio: 50 dB at 10 µV
Receive Antenna: Integral with earphone/headphone cord
Audio Output: 250 mW, max. at 16 Ohms
Output Connector: 3.5 mm mini phone jack, also serves as a
charging jack for rechargeable battery
Earphone: Earbud-type with foam cushion,
3.5 mm plug, 32 Ω
Note: The R7 Receiver can be field tuned to any of
10 wideband channels using the PLT 005
Tuning Tool.
PERSONAL PA Receiver, Model PPA R7
Dimensions & Weight: 3-5/8" L x 2-3/8" W x 7/8" H
(92.1 mm x 60.3 mm x 22.2 mm)
3.2 oz (90 g) with battery
Color: Gray
Battery Type: 9 Volt, Eveready 216 Carbon Zinc,
Eveready 522 Alkaline, or BAT 003 NiMH
Battery Drain: 14 mA, nominal
Battery Life: 10 hours with Eveready 216
32 hours with Eveready 522
6 hours/charge with BAT 003
FCC ID: CNM R7Y
Operating Freq.: Pre-Tuned, Adjustable, 72 MHz - 76 MHz *
Intermediate Freq.: 70 kHz
FM Deviation: 75 kHz
De-Emphasis: 75 µS
Dimensions, Weight: 8.45" (21.5 cm) W x 8.18" (20.8 cm) D
x 1.72" (4.4 cm) H, 3lbs. (1.5 kg)
Color: Black epoxy paint with white legends
Rack Mount: One EIA rack space high, 1/2 space wide
1–2 units can be mounted in a single rack
space with optional RPK 005 (single) or
RPK 006 (double) Rack Mount Kits
Power: 21 VAC minimum; 26 VAC maximum,
50 or 60 Hz 4.8 VA nominal; 10 VA maximum;
Wall mount transformer for 105 to 130 VAC
included
FCC ID: CNMT4
Operating Freqs: 72.1–75.9 MHz *
10 wide–band channels, selectable
Frequency Accuracy: ±.005% stability, 0-50˚ C
Deviation: ± 75 kHz maximum
Pre-Emphasis: 75 µsec
RF Field Strength: Does not exceed 8 mV/m at 3 m
Nominal Range: 300-500 ft. (90-150 m)
Audio Proc. Functions: Soft Knee Limit or Compress
Compression 10 dB add’l gain when input is –20 dB
20 dB add’l gain when input is –40 dB
Soft Limiting > 10 dB add’l gain when input is –45 dB
Frequency Response: 30 – 16000 Hz, +1, -3 dB
Signal to Noise Ratio: More than 70 dB below 75 kHz deviation
in Limit mode
Note: Maximum transmitter range is achieved
using the ANT 005 coaxial antenna
Power Indicator: Green LED
Audio Level Control: Rotary pot, screwdriver adjust,
used with audio level indicator lights
Audio Level Indicators: 4 LED array, reads -12, -6, 0, and +6 dB
RF Carrier On Indicator: Green LED indicates transmitter RF is on
Phones Jack: 1/4" TRS (Stereo) jack
T4 Transmitter Front Panel
T4 Transmitter Rear Panel
Power Connections: 3-pin Molex
®
connector
Input Levels Minimum Nominal Maximum
Microphone 100 µV 1 mV 100 mV
Bal or Unbal Line 10 mV 100 mV 10 V
Bal or Unbal or
70 V speaker line 2.3 V 23 V 230 V
IMPORTANT: If you choose to connect to 70 Volt Speaker line,
be certain to set the Audio Config switch correctly. Severe
damage will occur if you do not.
Audio Select Switch: Eight–section DIP switch
Audio Input: Combination 3-pin XLR, 1/4" TRS jack
Line Output: RCA jack, 0.6 V output impedance 1000 Ω
FM Channel Switch: Eight–section DIP switch (Seven used)
Antenna Outputs: Hard-wired 75 Ω Coaxial Antenna (ANT 005)
uses RG-59 cable, 400 ft. (122 m) max.
cable length
* Note: FCC Rules limit the use of the 72–79 MHz band to hearing assistance for the handicapped only.
Comments to this Manuals