Williams Sound PPA R37 User's Guide download pdf (Page 24)

TROUBLE SHOOTING

THE T35 “ON AIR” INDICATOR IS NOT ON

þ Make sure the transformer (TFP 016) is plugged into the transmitter and any remote power

switch is on.

þ Make sure the electrical outlet is on.

þ Make sure the power button on the front of the T35 is pressed to the “on” position.

þ Make sure the 24 VAC power supply is working.

þ Make sure the RF output is not set to “OFF AIR.”

NO AUDIO HEARD IN PHONES JACK

þ Check to see if there is a signal coming from your audio source. Check and correct your audio

source if necessary.

þ Check to see if the Headphone Volume Level has been turned all the way down. If so, increase it.

þ Check to see if there is an incorrect or defective connection from your audio source. See page 7 for

detailed connection instructions.

NOISE OR DISTORTION IN THE AUDIO

þ Check to see if there is noise in the audio source. To find out, disconnect the audio cable. If the

noise disappears your noise problem is in the source. Correct or repair your audio source.

þ Perhaps the Audio Source control is not set to match your audio source input device. See page 15 to

properly configure the Audio Source control menu.

þ Check to see if the Audio Input level is set too high. If the “input overload” is illuminated, then the

audio level needs to be adjusted. See page 10.

Check for ground loops or noise on the input signal. See page 9 for more information. Call your

Authorized Williams Sound dealer or representative.

NOISE IN AUDIO “GROWS” WHEN PROGRAM IS SILENT

þ The Audio Level Control may be set too high.

You’re probably also seeing the +6 level indicator

lighting all the time.

o correct, adjust the Audio Level control on the front of the T35. See page 10.

þ It could be that the T35 Audio Processor is set for Normal Compression, which may be inappropriate

for the type of program being transmitted. Reset the Compressor Gain control to of

f. See

page 17.

þ It could be that the

T35 Compressor Slope ratio is set to 2:1, which may be inappropriate for the

type of program being transmitted. Reset the Compression Slope control to 1:1. See page 16.

RECEPTION (A

RECEIVER

) DIFFICUL

TIES

NOTE: Be sure to listen to the audio transmission on the T35 phone jack prior to checking the

receiver reception.

NO RECEPTION

þ Check to see if the antenna on the T35 has been disconnected. If so, attach the antenna correctly.

þ Check to see if the RF output power on the T35 is set to “OFF.” If so, reset the RF Output control to

FULL, MEDIUM or LOW power. See page 18.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Williams Sound PPA R37 User's Guide Page 24

Comments to this Manuals

Related products and manuals for Receiver Williams Sound PPA R37