Williams Sound PPA T46 Operations Instructions download pdf (Page 6)

8. To install the belt clip on the rear of the T46, position the

belt clip on the back of transmitter. Turn the belt clip 180˚

left or right to secure the clip. The transmitter can now be

clipped onto a belt. To remove, turn the belt clip 180˚ so

the open end of the clip points up, and gently pull the belt

clip off. (FIG. E)

FIG. E: Belt Clip Installation

A119

9. Position the headset microphone boom as close to the

speaker’s mouth as possible without actually touching.

Lapel clip microphones should be attached to a collar or

lapel, as close to the speaker’s mouth as possible

10. When you pause from speaking, mute the microphone by

pressing the “ON/OFF/MUTE” button once momentarily.

The button will ash. The front display will also indicate the

mic is muted. To unmute the mic, press the button once

momentarily again.

11. When the T46 transmitter is not being used, turn the unit

OFF by pressing and holding the “ON/OFF/MUTE” button

for three seconds. The Power On indicator will go off.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Williams Sound PPA T46 Operations Instructions Page 6