Williams Sound PPA R7 User's Guide Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Williams Sound
®
Helping People Hear
21
RECEIVER MODEL PPA R35-8
The PPA R35-8 is an eight channel receiver, operating on 72-76 MHz bandwidth. It features a chan-
nel selection knob, volume on/off control, LED power and low battery indicator, and an earphone
jack (See Figure 15). Instructions:
BATTERY INSTALLATION
Install two (2) AA alkaline or NiMH rechargeable batteries. Open the battery compartment by
lifting the tab on the back of the receiver with a finger. To remove depleted batteries, pull up on
the fabric strip. IMPORTANT: If Alkaline (non-rechargeable) batteries are being installed, slide
the battery selection switch above the battery compartment to the “Alkaline” position. If
installing NiMH (or rechargeable) batteries, slide the battery selection switch to the “NiMH”
position. Press the batteries into place over the fabric strip. Be sure to observe proper polarity
(+/-). Damage due to improper battery installation may void the warranty on the product. Close
the battery door. When the sound becomes weak or distorted, replace or recharge the batteries.
NOTE:
The “ON” indicator on top of the unit will flash to indicate low battery
.
CONNECTING EARPHONES
Plug the earphone into the “EAR” jack on the top of the unit. Only monophonic earphones will
operate properly. If stereo headphones are used, sound will be heard only in one side. Williams
Sound evaluates each earphone and headphone used with the PP
A R35-8 receiver; we can only
assure optimum performance when Williams Sound earphones and headphones are used.
OPERA
TING
THE
RECEIVER
Plug the earphone or headphone into the Headphone jack on the receivers control panel. Turn the
receiver on by rotating the Volume control knob. The ON indicator should illuminate RED. Select
the channel you’d like by turning the channel selector on the control panel. Choose between 8
standard frequencies:
72.1, 72.3, 72.6. 72.8, 74.7, 75.4, 75.7, or 75.9 MHz. IMPORTANT: Make
sure the receiver frequency matches the transmitter frequency! Adjust the volume to a comfortable
listening level.
T
o turn the receiver of
f, rotate the
V
olume control knob to the left until it clicks of
f.
The ON indicator should not be lit. To prolong the battery life of the unit, turn the receiver off
when it is not in use.
On/Off Volume
Switch Control
Headphone
Jack
"On"/Low Battery
Indicator LED
Channel
Selector Knob
FIG. 15
R35-8 Top
R35-8 Front
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Comments to this Manuals

No comments