Williams Sound PPA R7 User's Guide download pdf (Page 7)

Williams Sound

Helping People Hear

POWER SUPPL

CONNECTION

FOR

U.S. APPLICA

TION

Connect the

TFP 016 power supply to the “Power In” jack located

on the rear of the T35 transmitter.

NOTE: The power on the T35 will not be activated until the power button

on the front of the T35 is pressed into the “on” position.

AUDIO SOURCE CONNECTIONS

The T35 transmitter will accept the following audio sources:

1) Balanced Microphone on a 3-pin (XLR) connector without simplex power.

Balanced Microphone with 12 volt simplex power (DIN 45596) on a 3-pin (XLR) connector.

3) Balanced/Unbalanced microphone without power on 1/4 inch jack

4) Balanced/Unbalanced Line on a 3-pin (XLR) connector.

5) Balanced/Unbalanced Line on 1/4 inch jack.

ARNING:

The T35 is not

designed to accept 70 volt speaker wire! This may result in damage

to y

our system. The sound source should come directly from the system mixer or amplifier as an

unprocessed signal.

NOTE:

If using a

Williams Sound MIC 044 headset microphone with a 3.5mm plug, you MUST

use it

with a

WCA 083 electret adapter. The T35 will not supply simplex (phantom) power through the 1/4” jack

without an adapter.

IMPORTANT: When a suitable audio source has been selected, you MUST

configure the audio source

controls on the front panel of the T35. There are three possible selections to choose from: MIC, SIMPLEX-

MIC and LINE. SEE

PAGE 15

FOR AUDIO SOURCE CONTROLS. After the audio source selection

has been made, plug in the appropriate audio source into the “Audio Input” jack in the rear of the T35.

FIG. 5: REAR VIEW

T35

TFP 016

Power

Supply Plug

WIRING AND CONNECTIONS

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Williams Sound PPA R7 User's Guide Page 7

Comments to this Manuals

Related products and manuals for Receiver Williams Sound PPA R7