Williams Sound PPA R38 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
PPA R38 FM Receiver
A311
ALKALINE/
NiMH SWITCH
CAUTION: RECHARGE
ONLY NiMH BATTERIES
BATTERY REMOVAL
FABRIC STRIP
Initial Setup
1. Open the battery compartment. Slide the battery selection switch
to the correct position for the type of batteries that will be used. Use
“Alkaline” for non-rechargeable batteries, “NiMH” for rechargeable
NiMH batteries (only). (Figure. A)
IMPORTANT: If the battery switch is not in the correct position,
damage may be caused to the unit. Alkaline batteries cannot be
recharged.
2. Install the AA batteries. Be sure to observe proper polarity (+/-).
Damage due to improper battery installation may void the warranty
on the product. The battery icon on the display and the “Power On”
LED on top of the unit will ash when the batteries are getting low;
you may continue to use the receiver until it quits operating, then
replace or recharge the batteries. (Figure. A)
3. Plug in an earphone, headphone, or neckloop using the
3.5mm jack on the top of the receiver. Note that the earphone,
headphone or neckloop cable is also the receiving antenna.
(Figure B)
Figure B: Headphone Jack
A448
3.5mm STEREO
EARPHONE/
HEADPHONE
JACK
R38 TOP
Figure A: Battery Compartment
SOFT AUDIO TURN-ON
When powered on, or if the channel is changed, the receiver will
mute the audio, then gradually bring the audio level up to the current
volume setting. This setting can either be the last volume used, or a
specic volume level. See “Volume Level at Turn On” under “Hidden
Settings”.
4. To install the belt clip on the rear of the R38, position the belt
clip on the back of transmitter. Turn the belt clip 180˚ left or right to
secure the clip. The transmitter can now be clipped onto a belt. To
remove, turn the belt clip 180˚ so the open end of the clip points up,
and gently pull the belt clip off. (Figure F)
A119
A119
Figure C: Belt Clip Installation
Page view 4
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments