Williams Sound PPA R38 User Manual download pdf (Page 7)

7

PPA R38 FM Receiver

3. VOLUME: Adjust the volume level

to your taste by using the left or right

arrow buttons. This can only be done

from the home screen. The display

will indicate the current volume level.

Advanced Settings

The Advanced Setup Menu provides the

ability to change between ‘channel’ and

‘frequency’ display mode, adjust the squelch,

change the receiver to 8 or 17-channel

mode, change the amount of time for the

display to time-out, change the screen

brightness, or restore factory default settings.

1. ADVANCED SETUP MENU: To access

the Advanced Setup Menu, push-and-hold

the Menu button for 3 seconds until you see

the “LOADING ADVANCED SETUP” screen

displayed.

Within the advanced menu, pressing the

menu button will advance to the next

setting.

2. SQUELCH: This is the rst screen in the

Advanced Menu. The receiver will silence the

audio if the RF signal strength falls below a

certain level. The squelch adjustment sets

the level of RF signal strength at which the

audio will be muted. This has the effect to

the listener of eliminating static when the

broadcast signal is weak. Push the left or right

arrow buttons to adjust the squelch level (1-4).

3. CH/FREQ DISPLAY MODE: To change

the display to show either channel number

(1-17) or frequency (72.1-75.9MHz) push the

left or right arrow buttons to toggle between

“CH NUMBER” or “FREQUENCY”.

4. 8/17 CHANNEL MODE: 17-channel

mode allows the receiver to change to any

one of the 17 possible broadcast channels.

8-channel mode restricts the receiver to the

8 non-interfering (simulataneous broadcast)

channels. To change the receiver between

8-channel and 17-channel modes, use

the arrow buttons to toggle between “17

CHANNEL MODE” or “8 CHANNEL MODE”.

5. DISPLAY TIME-OUT: This feature

sets the amount of time before the display

turns off. Use the left or right arrow buttons

to toggle between “5 SECONDS” “30

SECONDS” or “60 SECONDS”. Note that

even though the display is off, the receiver

still continues to function.

6. SCREEN BRIGHTNESS: To change the

display brightness (level 1-4), use the left,

right arrow buttons to toggle between “1”,

“2”, “3” or “4”.

7. RESTORE FACTORY SETTINGS: The

next screen shows: “ERASE ALL SETTINGS

RESTORE DEFAULTS?” (below).

To reset, push the right arrow button to

choose “YES”. After this you will see the

conrmation screen “FACTORY DEFAULTS

RESTORED”, followed by the home screen.

If you chose “NO” to NOT reset, you will be

returned to the squelch screen (step 2).

8. At any time, the Advanced Setup menu

can be exited in three different ways:

a. Push and hold the menu button for 3

seconds, or

b. wait 20 seconds without pushing any

buttons, or

c. repeatedly push the menu button until

you see the screen “EXIT ADVANCED

SETUP?” screen. Push the right arrow

button to choose “YES”. The Home

Screen will then be displayed.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments